If your not sure what you need please call us first! Rememeber, these lines are custom and cannot be returned for any reason.

Custom Nitrous Lines-- Made to Order. We make and ship your line typically the same day. We use the highest quality line and fittings. Braided stainless with teflon inner tubing.

1) Pick your line length from tip to tip(very end of the an fittings) in .5  inch increments: example Line length 12.5-24 inches - $19.95

2) Enter line length tip to tip: example Enter Line Length Tip to Tip In Inches,  .5 inch steps : 22.5 inches

3) Pick your line size: example -3 Size Line(Typical Goes To Wet Or Dry Nozzles)

3) Pick your fitting on one end of the line: example Blue 3AN (Fogger Nozzle size)

4) Pick your fitting on the other end of the line: example Blue 3AN (Fogger Nozzle size)

You can mix and match fittings and line sizes for serious custom lines. example, put -3 Blue nuts on -4 size line...

Refrence info:

-3AN Nuts use a 7/16" wrench

-3AN Lines are about .25" wide

-4AN Nuts use a 9/16" wrench

-4AN Lines are about .30" wide

"AN" means Army Navy...they are flare fittings and require no teflon paste or tape to seal them.

"NPT" means national Pipe thread.... they are tapered and require teflon tape or sealer to seal. Teflon tape seals the best, use 4 wraps around the fitting keeping the tape about one thread from the end.

If your not sure what you need please call us first! Rememeber, these lines are custom and cannot be returned for any reason.